(Right), Components

NOTES:
- Removal description is given for only one side, other side is mirror image
- Depending on equipment installed, remove seats and/or seat benches See 'Body And Frame, Seats.' Service and Repair , for storage area See 'Accessory Compartment.'
- To remove rear side panel molded trim, remove rear headliner trim, left upper B-pillar trim, left C-pillar trim, D-pillar trim, loosen rear edge cover on both sides. See 'Body And Frame, Interior Trim.'







1 - Gasket
- After installing rear side panel molded trim, ensure correct positioning.
2 - Clip
- Two-piece
- Place sleeve in C-pillar hole and install pin.
3 - Spring clip
4 - Clip
- On back
- Several located along window edge.
5 - Cap
- From 12/91
- Up to 11/91, clip, item 7
6 - Plug
- From 12/91
- Up to 11/91, clip, item 7
7 - Clip
- Removing. Remove inner part with Allen wrench
- Installing: Press outer part and inner part into hole simultaneously
8 - Door stop cover
9 - Cover
10 - Trim plug
11 - Phillips screw
12 - Belt guide with closure strip
13 - Cover
14 - Hex bolt
- 40 Nm (30 ft lb)
15 - Spacer
16 - Phillips screw
- with washer and cap
17 - Rear side panel molded trim
- Removing/Installing See 'Trim Panel.' Service and Repair