Front Side Panel Molded Trim

NOTE:
- Removal description is given for only one side, directions for the other side are mirror image.
- To remove front side panel molded trim, remove left upper B-pillar trim , left C-pillar trim .
- Left rear side panel molded trim (short wheel base), and/or right side panel molded trim (long wheel base), loosen only where it overlaps front side panel molded trim. See 'Removing/Installing See 'Trim Panel.' Service and Repair
- Two-place bench and/or individual seat must be removed See 'Body And Frame, Seats.' Service and Repair







1 - Clip
- Two-piece
- Removing: Remove inner part with Allen wrench
- Installing: Press outer and inner part into hole simultaneously
2 - Clip
3 - Gasket
- After installing front side panel molded trim, ensure correct gasket positioning.
4 - Seat belt anchor point
5 - Front side panel molded trim
- Removing/Installing See 'Trim Panel.' Service and Repair
6 - Clip
- On back
- Several along window edge
7 - Spacer bushing
8 - Hex bolt
- 40 Nm (30 ft. lb)
9 - Cap
10 - Phillips screw
11 - Belt guide with closure strips
12 - Ashtray
- Removing: Pull upward and out of molded trim
- Installing: Press into molded trim until spring engages audibly