Cooling System Components, Engine Side

COOLING SYSTEM COMPONENTS, ENGINE SIDE:



1 - Toothed belt guard, lower section
^ Removing: take off vibration damper (if necessary)
2 - Toothed belt guard, upper section
3 - Camshaft sprocket securing bolt
^ Observe steel type marking on bolt head:
8.8 = 85 Nm (63 ft lb)
10.9 = 100 Nm (74 ft lb)
^ Counter-hold with 3036 to loosen and tighten
4 - Camshaft sprocket
^ Note position when installing toothed belt Service and Repair
5 - Woodruff key
^ Ensure tight fit
6 - 10 Nm (7 ft lb)
7 - Toothed bolt guard, rear
^ to remove, take oft vibration damper, if necessary
8 - Oil cooler
^ Removing and installing Service and Repair
9 - Coolant hose
Vehicles up to 12.95
Vehicles 01.96 to 07.96
Vehicles from 08.96
To throttle valve control module
10 - to coolant pipe
11 - 0-ring
^ Replace if damaged
12 - 20 Nm (15 ft lb)
13 - Coolant pump
^ Check shaft for ease of movement
^ Replace complete if damaged or leaking
^ up to 09.91 with elongated holes: to tension toothed belt: loosen slightly and turn with screwdriver Service and Repair
14 - Tensioner
^ from 10.91
^ Removing and installing Service and Repair
15 - Woodruff key
^ with locking tab
16 - 15 Nm (11 ft lb)
17 - 2O Nm (15 ft lb)