Ignition Switch Lock Cylinder: Service and Repair

Lock Cylinder, Removing And Installing

Removing
- Removing steering lock housing







- Mark steering lock housing for drilling
a - 12 mm (.5 in.)
b - 10 mm (.4 in.)
- Drill steering lock housing (approx. 3 mm, (.12 in.)), until the lock cylinder spring is evident (hole depth approx. > 3 mm, (.12 in.)).
- Using opposite end of drill compress lock spring and pull out lock cylinder.

Installing


CAUTION! The original steering lock housing must not be reinstalled.


- Push lock cylinder into steering lock housing.
- By slightly turning key in lock cylinder it can be pushed onto the stop.