Multi-Pin Plug Behind Relay Plate, Removing and Installing

Multi-pin Plug Behind Relay Plate, Removing And Installing


NOTE: Multi-pin connector pin assignment


Removing Multi-pin Plug







- Pull the retaining slide -1- on rear of relay plate out of the housing -arrow- as far as possible (about 5 mm).







- Press retaining lug on multi-pin connector -arrow- and pull out of relay plate.







Installing multi-pin connector


NOTE: Insert connector so that the locking pin - 2- face towards locking slide -1-.


- Push multi-pin connector into appropriate location as far as stop with locking pin -2- located in recess -4- until retaining tab -3- engages.
- Push locking slide -1- against stop - arrow-; only possible when all multi-pin connectors are pushed in until the retaining tabs -3- are engaged.