Vehicle Damage Warnings

CAUTION: Before working on the electrical system:
- Determine the correct coding for the anti-theft radio.
- Disconnect the battery Ground (GND) strap.
- Be sure the ignition is switched OFF (also applies when connecting the battery). Failure to do so may damage the Engine Control Module (ECM).
- Disconnecting the battery causes the basic setting of the ECM to be erased. This may result in driveability problems.

Safety Measures when Working on EuroVan Electrical System:
- During repair work on any part of electrical system, the 110/220 V power source must be disconnected.
- 110/220 V repairs must be carried out either by an electrician or with the supervision of an electrician.
- If propane gas lines are opened during repair work, a pressurized leak test must be performed, prior to returning vehicle to service. Use soapy water or equivalent to check fittings.
- Disconnect battery Ground (GND) strap before working on electrical system.
- Note all appropriate regulations!