Horn: Testing and Inspection

Use test system V.A.G 1466 for troubleshooting!

Test Condition:
^ Fuse no. 13 0K!

Preparation for Troubleshooting:
- Remove dual horn relay J 4 (production control number 53) from relay location 11.
- Insert test adapter V.A.G 1466/3 into relay location 11.
- Connect V.A.G 1466 to test adapter.
- Switch on ignition.

Troubleshooting - Checking Dual Horn:

Troubleshooting Procedure:
- Perform test steps according to table.
- If specified value/test result is obtained, proceed to next step (test result OK).
- If specified value/test result is not obtained, use table for troubleshooting and repair.
- Use applicable wiring diagram for wire testing.
- Disconnect test leads after each step.

NOTE: If malfunction has not been eliminated after performing steps 1 to 3, replace dual horn relay J4.