Manual Transmission

Use test system V.A.G 1466 for troubleshooting!

Test Conditions:
^ Vacuum system for cruise control OK!
^ Fuse no. 14, OK!

Preparation for Troubleshooting:
- Remove double and 8-pin connectors at cruise control, control module J 213 behind center console.
- Insert test adapter V.A.G 1466/2 into wire harness.
- Connect V.A.G 1466 to test adapter.
- Connect remaining adapter contact with auxiliary wire to connector T2/i (wire 0.5 BL/BK).

NOTE: Contact T2/2 of double connector at cruise control, control module J213 is also used. Wire connection from T2/2 (wire 0.5 BR/BK) to ground must be checked.

Troubleshooting - Checking Cruise Control System (Manual Transmission):

Troubleshooting Procedure:
- Perform test steps according to table.
- If specified value/test result is obtained, proceed to next step (test result OK).
- If specified value/test result is not obtained, use table for troubleshooting and repair.
- Use applicable wiring diagram for wire testing.
- Disconnect test leads after each step.

NOTE: If malfunction has not been eliminated after performing steps 1 to 9, replace cruise control, control module J213.

- After repairing malfunction, perform functional test of cruise control.