Checking Windshield Wiper/Washer System

Use test system V.A.G 1466 for troubleshooting!

Test Condition:
^ Fuse no. 5 0K!
^ Windshield wiper in end position!

Preparation for Troubleshooting:
- Remove washer/wiper intermittent relay J31 (production control number 99) from relay location 8.
- Remove rear window wiper/washer relay J30 (production control number72) from relay location 2.
- Insert test adapter V.A.G 1466/5 into relay location 8.
- Connect V.A.G 1466 to test adapter.
- Switch on ignition.

Troubleshooting - Checking Windshield Wiper/washer System:

Troubleshooting Procedure:
- Perform test steps according to table.
- If specified value/test result is obtained, proceed to next step (test result OK!).
- If specified value/test result is not obtained, use table for troubleshooting and repair.
- Use applicable wiring diagram for wire testing.
- Disconnect test leads after each step.

NOTE: If malfunction has not been eliminated after performing steps 1 to 8, replace washer/wiper interment relay J31.

- After repairing malfunction, perform functional test of windshield wiper/washer system.