Assembly Overview

Assembly Overview (From 01.96)







1 - Hood
- Apply corrosion protection to hinge and screws after installation or adjusting procedures.

2 - Hood lock
- To remove:
- Remove insulation (if applicable).
- Remove hood release cable bracket (press latch hook to left).
- Remove screws and lock.
- Disconnect cable.

3 - Screw
- 23 Nm
- Fore/aft adjustment

4 - Hinge
- Two piece

5 - Hex bolt
- 23 Nm
- To adjust gap between hood and fender

6 - Nozzle
- Cowl grille must be removed to remove nozzles

7 - Clip
- Rotate clip 180° to remove

8 - Cable
- Cable connected

9 - Clip
10 - Lid support
11 - Rubber bumper
12 - Bonded rubber bushing
13 - Cowl gasket
- Installed on flange

14 - Clip
15 - CW gasket
16 - Blind rivet
17 - Bracket, lid support
18 - Clip
19 - Hose