Rear Side Molded Trim (Left Side, Short Wheel Base), Components

Rear Side Molded Trim (Left Side, Short Wheel Base), Components

NOTE:
- Removal description is given for one side, opposite side is mirror image.
- Depending on equipment installed, remove seats and/or seat benches, for storage area.
- To remove rear side molded trim, remove rear headliner trim, left upper B-pillar trim, left C-pillar trim, D-pillar trim, loosen rear edge cover on both sides.







1 - Cover
2 - Clip
- Two-piece
- Removing: inner section requires an Allen wrench.
- Installing: Press outer and inner part into hole simultaneously.

3 - Rear side molded trim
4 - Clip
- On back
- Several located along the window edge

5 - Hex bolt
- 40 Nm (30 ft lb)

6 - Automatic tensioning seat belt retractor
7 - Hex bolt
- 40 Nm (30 ft lb)

8 - D-ring for seat belt
- Can be taken off with two-piece trim

9 - Three-place bench seat belt anchor point
10 - Spring clip
11 - Seat belt
12 - Speaker cover
13 - Speaker with connector
14 - Phillips screw
- With washer and cap

15 - Spacer
16 - Belt anchor
17 - Hex bolt
- 40 Nm (30 ft lb)
- With cap

18 - Belt guide with closure strips
19 - Trim plug
20 - Phillips screw
21 - Trim plug
22 - Guide cover
23 - Phillips screw