Front Molded Side Panel Trim, Removing And Installing

Front Molded Side Panel Trim, Removing

- Remove upper B-pillar trim and C-pillar trim.
- Remove single seat (passenger compartment).
- Unlatch table by pressing inward, and fold out.







- Loosen bolts - 1 - on table top mount and disconnect support at catch - 2 -.
- Remove table top with top section of support.







- Remove inner sections of clips - 1 - with Allen wrench.
- Pry off cap - 2 -, remove hex bolt with washer.
- Remove recessed screw - 3 -, carefully pry out belt guide with locking panel - 4 -.
- Loosen molded trim at rear in area of overlap with side panel molded trim front.







- Unclip side panel molded trim front, in following order:
- B - pillar - arrow A -
- Window pillar - arrow B -







- Pull off front of side panel molded trim, near B-pillar, push as far as possible in direction of travel.
- Disconnect connector for 12 V Socket - U5 -.
- Pull off molded trim - top - near table - 1 - mount, fold down mount and lift molded trim over bottom support - 2 -.

Front molded side panel trim, installing







- Install in reverse sequence and note the following:
- Clip side panel molded trim in at front, ensure seal - arrow A - is positioned correctly.