Front Side Panel Molded Trim, Component Layout

Front Side Panel Molded Trim, Component Layout







Part I
Part II

NOTE:
- To remove front molded trim, remove upper B-pillar trim: and C-pillar trim.
- Only loosen side panel molded trim at rear.
- Single seat (passenger compartment) is to be removed.

Part I







1 - Table top
2 - Mount
- Screws on body

3 - Side panel molded trim, front
4 - Catch
- Table folded down

5 - Support
6 - Bolt
- With washer

7 - Catch
- To remove table, disconnect support

8 - Bolt

Part II







1 - Clip
- 2-part
- Removal: Remove inner section with Allen wrench.
- Installation: press in outer section and inner section simultaneously into mounting hole.

2 - Cup holder
- Removal => fig. 1

3 - Mount
- Fastened onto body
- For table top

4 - Bracket
5 - Seal
- After mounting side panel molded trim front, ensure seal makes proper contact.

6 - Securing point for seat belt
7 - Connector, 12 V Socket - U5 -
8 - Side panel molded trim, front
9 - 12 V Socket - U5 -
10 - Support, bottom section
- Fastened to body

11 - Washer
12 - Hex bolt
13 - Cap
14 - Recessed screw
15 - Belt guide with locking panel
16 - Ash tray
- Removal => fig. 2

17 - Clip







Fig. 1
Cup holder,
removing







Fig. 2
Ash
tray,
removing
- Remove ash tray (inner section).
- Pry retaining lugs - 1 - over edge of molded trim recess with screwdriver.