Manual Air Conditioning

CAUTION: Before working on electrical system, obtain radio code and disconnect battery Ground (GND) strap.


NOTE:
- Illustrated control from vehicle with additional (rear) heat exchanger and (rear) passenger compartment ventilation.


1 - Connector, 6 pin -T6-
2 - Connector, 6 pin -T6c-
3 - Illumination filter
4 - Illumination bulb -L16-
5 - Control assembly
With:
- Fresh air blower switch -E9-
- Warm air blower switch -E100-
- Fresh air blower switch -E179-
- Removing and installing
See 'Control Assembly.' Service and Repair
- Temperature flap cable, installing and adjusting
See 'Air Duct Cable.' Service and Repair
- Footwell/defrost flap cable, installing and adjusting
See 'Air Duct Cable.' Service and Repair
- Central flap cable, installing and adjusting
See 'Air Duct Cable.' Service and Repair
6 - Rotary knobs
7 - A/C switch
With:
- A/C switch -E35-
- Fresh air/recirculating flap switch -E159-
- Illumination bulb -L43-
- Removing
See Fig. 1.
8 - Push button
9 - Control panel trim


Fig. 1 A/C switch -E35- and -E159-, removing







- Remove Heating & A/C controls See 'Control Assembly.' Service and Repair
- Disconnect electrical connector.
- Press switch at the four locating points arrows- against the controls and in direction of buttons simultaneously.