Oil Temperature Sensor/Switch: Service and Repair

Component Notes And Information

NOTE: During service procedures, refer to the illustration above and the information below.

1 Gasket
- Replace
- Note installed position
- Oil before installing
2 Oil pressure switch (0.3 bar) -F22-
- Tighten to: 20 Nm (15 ft lb)
- Brown body
- Blue/black wiring
- Checking. Testing and Inspection
- If sealing ring is leaking; nip open and replace
3 Oil filter bracket
4 Stop plate
- For oil cooler
- Mounted to oil filter bracket
5 Oil filter element
- Note replacement intervals with by-pass valve:
- Opening pressure: 2.0 bar
- Clip into lower oil filter section before installing
6 O-ring
- Oil before installing
7 Oil filter, lower section
- Tighten to: 30 Nm (22 ft lb)
- Drain before removing
8 Oil drain screw
- Tighten to: 10 Nm (7 ft lb)
9 Bolt
- Tighten to: 25 Nm (18 ft lb)
10 Oil pressure switch (1.4 bar) -F1-
- Tighten to: 20 Nm (15 ft lb)
- Black body
- Yellow wiring
- Checking. Testing and Inspection
- If sealing ring is leaking; nip open and replace
11 Engine Oil Temperature sensor -G8-
- Tighten to: 10 Nm (7 ft lb)
- Green/black wiring