Multi-Pin Connectors of Fuse/Relay Panel, Remove/Install

Multi-pin Connectors Of Fuse/relay Panel, Removing And Installing

Removing







- Pull retaining slide -1- on rear of fuse/relay panel out of housing -arrow- as far as possible (about 5 mm).







- Depress retaining lug on multi-pin connector -arrow- and pull out of socket.

Installing


NOTE: Insert connector so locking pin -2- faces locking slide -1-.







- Push connector into socket as far as stop with locking pin -2- located in recess -4- until retaining tab -3- engages.
- Push locking slide -1- against stop -arrow-; only possible when all multi-pin connectors are pushed in until the retaining tabs -3- are engaged.