Throttle Valve Control Module, Removing/Installing

Throttle Valve Control Module, removing/installing







1 - 8-pin harness connector
- Black
- For Throttle Valve Control Module -J338-
- Only disconnect/connect with ignition switched off
2 - M8: 25 Nm (18 ft lb)
M6: 10 Nm (7 ft lb)
3 - Throttle Valve Control Module -J338-
- Components: Throttle Position Actuator -V60- Throttle Position sensor -G88-, Throttle Position sensor -G69- and Closed Throttle Position switch -F60-
- Heated by engine coolant
- If Throttle Valve Control Module is replaced, perform "Basic setting".
4 - Gasket
- Always replace
5 - Connection
6 - Breather hose
- Hose must not contact adjacent components!
- From EVAP canister purge regulator valve N80
- Part of EVAP system
7 - Exhaust Gas Recirculation valve
8 - To brake-servo vacuum line
9 - Left rear support
- Between intake manifold and cylinder head
10 - Intake manifold
11 - Vacuum hose
12 - Support bracket
- For accelerator cable
- Accelerator cable, adjusting
13 - Oil seal
- Always replace
14 - Intake Air Temperature sensor -G72-*
- 15 Nm (10 ft lb)
15 - 2-pin harness connector
- Black
- For Intake Air Temperature sensor
16 - Coolant hose