With Manufacturer Scan Tool

Erase DTC Memory, End Output

Erase DTC Memory

- Connect Scan Tool (ST), Initiate On Board Diagnostic (OBD). Scan Tool Connecting and Initial Checks

- Switch printer on via the print-button (indicator lamp in button lights up).

Requirements

- Malfunction was repaired
- DTC memory was checked again Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -5- to select "Erase DTC Memory", function 05.

Indicated on display:


Rapid data transfer Q
05 - Erase DTC Memory


- Press -Q- button to confirm input.

Indicated on display:


Rapid data transfer ->
DTC Memory is erased!


- Press -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX


NOTE:


WARNING!
DTC memory was not checked


- Test sequence is faulty if this message is displayed.
- Follow test sequence exactly: first check DTC memory, then erase it.

End Output

- Press buttons -0- and -6- to end output.

Indicated on display:


Rapid data transfer Q
06 End Output


- Press -Q- button to confirm input.

Indicated on display:


Rapid data transfer HELP
Enter address word XX


- Switch off ignition.
- Disconnect harness connectors for the V.A.G 1551 scan tool.