Window, Rear - Installing New Support Brackets
84VW1Applies To
Rabbit Convertible
1980-1984
Group
61
Subject
Rear Window Support Brackets
Part Identifier 6147
Key Points
Procedure for installing new support brackets
C
Number
84-02
August 2, 1984
New rear window support brackets have been installed at the factory as of 12/83:
VIN # 15EK009782
The new brackets can be installed in all Rabbit Convertibles providing the brackets on both sides are replaced.
Work procedure
- cut tie wraps retaining heated rear window harness wiring on window support brackets
- remove existing window support brackets (four bolts on each side)
- mount new support bracket on rear window frame (hand tighten only)
Note
Forward end of bracket will rest on side shelf.
- push forward end of bracket rearward approx.. 5 mm and mark new hole locations in side shelf
- pull up shelf carpet and drill two 5.5 mm (0.216 in.) holes in side shelf
Note
Holes may already be drilled in correct location on some vehicles.
- remove bracket from window frame
- cut a 30 mm (1-3/16 in.) slot in shelf carpet above drilled holes
- install support bracket through slit in carpet
- mount bracket to window frame and tighten bolts
- install bolts in bracket at side shelf and tighten
^ bolt Part No. N 033 023.1
- glue carpet to side shelf with contact cement
- secure heated rear window harness wires to brackets with tie wraps.
CAUTION Part numbers are listed for reference only. Always consult with the Parts Dept. for latest information.