Engine, Cooling and Exhaust: Technical Service Bulletins
- Recalls
- Customer Interest
- Fuel System - Poor Engine Performance
- Coolant Pump - Leakage, Warning Lamp On, Residue
- Radiator Fan - Stays On High Speed When Extremely Cold
- Alternator - V Belt Slips Under Load
- Engine Oil Cooler - Leaks into the Cooling System
- Oil Dipstick Tube - Loose Fit on Remanufactured Engines
- Coolant Temperature Gauge Light - Flashes
- Exhaust Swivel Joint - Squeaks While Driving
- Coolant Indicator LED - Flashing At Normal Temp
- MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke
- By Symptom
- Continuous fan operation
- Customer Interest
- Fuel System - Poor Engine Performance
- Coolant Pump - Leakage, Warning Lamp On, Residue
- Radiator Fan - Stays On High Speed When Extremely Cold
- Alternator - V Belt Slips Under Load
- Engine Oil Cooler - Leaks into the Cooling System
- Oil Dipstick Tube - Loose Fit on Remanufactured Engines
- Coolant Temperature Gauge Light - Flashes
- Exhaust Swivel Joint - Squeaks While Driving
- Coolant Indicator LED - Flashing At Normal Temp
- MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke
- Driveability
- False instrument warning light/gauges
- Inoperative
- Leaks
- Loose
- Noise
- Odors
- Poor performance
- Recalls
- All Technical Service Bulletins
- Fluids and Lubricants - Warranty Reimbursements
- Engines And Short Blocks - Label Information
- Tools - Engine/Transmission Oil Temperature Tester
- Engine - Oil Consumption
- Tools - Support to Remove/Install Engine, Transmission
- Fuel Filter - Installing Water Indicator Kit
- Fuel System - Poor Engine Performance
- Connecting Rod Bolt - Stretch Bolt Tightening Procedure
- Engine - Attach Pressure Plate or Flywheel to Crankshaft
- Cylinder Head - Modified to Accept 12 mm Bolts
- Cylinder Block - Eliminating Non-Rebuildable Blocks
- Water Pump - Testing Procedure
- Coolant Pump - Leakage, Warning Lamp On, Residue
- Radiator Fan - Stays On High Speed When Extremely Cold
- Alternator - V Belt Slips Under Load
- Exhaust System - Removing Spring Clamps Using Wedge Tool
- Engine Oil Cooler - Leaks into the Cooling System
- Fuel Injector - Opening Pressure Requirements
- Oxygen Sensor - Failure Due to Silicone
- Recall 85V015000: Throttle Shaft Breakage
- Exhaust - Sulfur Odor Noticed At the Pipe
- Oil Dipstick Tube - Loose Fit on Remanufactured Engines
- Coolant Temperature Gauge Light - Flashes
- Voltage Stabilizer - Adding Diode To Circuit
- Cylinder Head Bolts - Tightening Procedures
- Exhaust Swivel Joint - Squeaks While Driving
- Glow Plug - Correct Torque
- Engine - Approved Oil And Additives
- Coolant - Revision
- Coolant Indicator LED - Flashing At Normal Temp
- Crankshaft Drive Sprocket Bolt - Changed
- MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke