Power Steering

1. Raise and support front of vehicle.
2. Remove front wheels.
3. Drain and discard power steering fluid.
4. Disconnect pressure hose at steering gear.
5. Disconnect return hose at steering gear.
6. Disconnect tie rod ends at steering arm.
7. Remove left tie rod end from tie rod.
8. Remove rear motor/transaxle mount.
9. Remove exhaust pipe.
10. Remove clamp bolt at steering shaft.
11. Remove nuts from steering gear mounting clamps and remove steering gear assembly.
12. Reverse procedure to install, torquing steering gear assembly mounting clamp nuts to 22 ft. lbs., then fill power steering reservoir and bleed system.