Alignment: Service and Repair

CASTER ADJUSTMENT
The caster angle on these vehicles cannot be adjusted.

CAMBER ADJUSTMENT

FRONT

To adjust camber, loosen the cam and through bolts at strut bracket. Rotate the upper cam bolt until specified camber angle is achieved. Torque cam bolt to 58 ft. lbs. Torque through bolt to 50 ft. lbs. on models with self-locking bolts, or 36 ft. lbs. on models less self-locking bolts.


REAR

Camber on rear axle assembly is not adjustable.

TOE SETTING ADJUSTMENT

FRONT

The toe setting is adjusted by the right tie rod only on all models except Quantum. On Quantum and Fox models, the toe setting is adjusted by both tie rods, however, centering tool 3075 or equivalent must be used. Install tool with bracket over mounting nut on left tie rod.
Loosen clamp and locknut on tie rod. Rotate tie rod until specified toe setting is obtained, then tighten locknut securely.

REAR

Toe setting or rear axle assembly is not adjustable.