Drive-Belts, Component Layout

Drive-Belts, Component Layout





1 - 6 Nm (53 in. lb)
2 - Upper cover for drive belt
3 - 45 Nm (33 ft lb)
4 - Belt tensioner
5 - Drive belt
- Mark running direction before removing
- Check for wear
- Do not bend
- Removing, installing, tensioning
6 - 30 Nm (22 ft lb)
7 - 30 Nm (22 ft lb)
- Install using D6
8 - Rear drive belt cover
9 - Intermediate shaft
10 - Drive belt sprocket for crankshaft
11 - 65 Nm (48 ft lb)
12 - 90 Nm = 1/4 turn
- Loosen and tighten using tool 3099
- Replace hex head bolt with 12 point bolt and do not use a washer
- Oil threads before installing
- The extra 1/4 turn can be obtained in more than one motion
13 - Lower drive belt cover
14 - 10 Nm (7 ft lb)
15 - Vibration damper
- Can only be installed one way
- Note position when installing drive-belt
16 - V-belt
- Check tension between water pump and generator using thumb deflection method:
New belt = approx. 2mm
Used belt = approx. 5mm
17 - 20 Nm (15 ft lb)