Safety Precautions
Safety PrecautionsCAUTION: When working on vehicles with Digifant fuel/ignition system, observe the following precautions to prevent personal injury and/or damage to the ignition system:
- connect/disconnect ignition system wires (including high tension wires and test instrument wires) only when the ignition is switched OFF
- do NOT crank engine before high tension wire of ignition distributor (terminal 4) is connected to ground with jumper wire
- do NOT use battery booster longer than 1 minute or exceed 16.5 Volts with booster
- do NOT wash engine unless the ignition is switched OFF
- disconnect battery completely when arc or spot welding
- do NOT connect condenser to terminal 1
- do NOT substitute rotor of ignition distributor or radio noise suppressor with one of different type
- when installing suppressor, use only
1000 Ohms for high tension wires and
5000 Ohms for spark plug connectors
- do NOT allow terminal 1 of coil to contact ground. Possible destruction of the control unit could result