Federal Vehicles (Digifant II)

Distributor View:

NOTE: This procedure requires that the distributor is removed from the engine block. For distributor removal and installation procedure, refer to IGNITION SYSTEM.

1. Remove the distributor cap and rotor.
2. With snap-ring pliers, remove the trigger wheel snap ring.

Trigger Wheel Removal:

3. Use two screwdrivers positioned at opposite sides of the trigger wheel as shown. Insert the screwdriver as far as possible to avoid any damage to trigger wheel.
4. Pry the trigger wheel up and remove it from the shaft.

NOTE: Make sure you don't loose the small trigger wheel locating pin.

6. Remove following washer and snap-ring.
7. Remove remaining base plate retaining screws.
8. Remove Hall sender unit.
9. Reassemble in reversed order.

NOTE: Volkswagen recommends to always use new washers and snap-rings during the reassembly process.