California
COIL WIREWire (complete) resistance 1600 - 2400 ohms
Wire (only) resistance approx. 0 ohm
Cap connector resistance 600 - 1400 ohms
Coil connector resistance 600 - 1400 ohms
IGNITION COIL
Resistance between terminals 1 (-) and 15 (+) 0.50 - 0.70 ohms
Resistance between terminals 1 (-) and 4 (center) 3000 - 4000 ohms
IGNITION TIMING [1]
2250 ± 50 RPM Coolant temperature sensor disconnected
Checking 4° - 8° BTDC
Adjust to 6° - 1° BTDC
PLUG WIRES
Wire (complete) resistance 4800 - 7200 ohms
Wire (only) resistance approx. 0 ohm
Cap connector resistance 600 - 1400 ohms
Plug connector resistance 4000 - 6000 ohms
ROTOR
Resistance 600 - 1400 ohms
[1] Ignition timing, idle speed and CO need to be adjusted together to prevent driveablity problems. For complete procedure, see ADJUSTMENTS. Adjustments
Clear fault memory codes after disconnecting and reconnecting the coolant temperature sensor. If the base ignition timing has been changed, the control unit must be returned to reference settings. Refer to COMPUTERS AND CONTROL SYSTEMS