Check and Repair Procedure
RW RECALLCheck/install Preheating Tube-Support Bracket
WORK PROCEDURE
A. Check for Preheating Tube
Support Bracket
- Open hood
Check if support bracket is mounted to the engine compartment's right front shock tower, securing the routing of the preheating tube
- If the bracket is present, no further work is required
- Close hood
If the preheating tube support bracket is not present, proceed to Step B
B. Check/Replace Brake Line
Protect right front fender with cover
Remove air intake tube between air filter and throttle body
Check right front brake line in the vicinity below the preheating tube for possible chafing damage
If no chafing damage is visible, proceed to Step C - Install
Preheating Tube Support Bracket
^ If brake line shows chafing damage, proceed as follows:
- Disconnect preheating tube
- Disconnect and remove right front brake line
- Install new brake line, part number
191 611 996B
- Bleed brakes (front right and rear left), using power bleeder, US1116 or similar
Campaign Data Entry Procedure
Reimbursement Codes:
Note:
The system automatically supplies the part number(s) including price and labor applicable to the above reimbursement codes.
To update a record for a vehicle with no repair performed but relevant information available enter into the system one of the codes indicated as applicable:
- Top-off brake fluid in brake fluid reservoir to maximum mark
- Reconnect preheating tube
- Continue to Step C
C. Install Preheating Tube Support
Bracket
Locate two 8 mm bolts on right side shock tower
- Remove top bolt nut completely and loosen nut of the lower bolt
Attach new securing bracket, part number 191 129 648D, to the shock tower's 8 mm bolts
- Tighten 8 mm nuts
- Reinstall air intake tube
- Close hood