Bumper Covers - Installation
Group: 63Number: 93-01
Date: August 31, 1993
Subject:
Bumper covers, front/rear, installing
Model(s):
Golf/Jetta
m.y. 1990-1992 w/full bumper covers
This Technical Bulletin supercedes Technical Bulletin, Group 63, No. 91-02, dated 6/30/91
The following repair procedure applies to all 1990 through 1992 model year Golf and Jetta vehicles equipped with full bumper covers
Bumper covers, Installing
When installing or replacing bumper covers, the following steps must be taken to ensure proper bumper cover retention.
- Inspect the plastic retaining clips which are molded into the inner surface of the bumper cover. If the clips are deformed or damaged, replace the bumper cover.
- Slide the bumper cover over the bumper support assuring that the bumper cover ends are interlocked with the fender mounted retaining clips.
- Reach behind the bumper support to ensure that each bumper cover retaining clip is properly aligned with the rectangular openings in the bumper support.
- Carefully tap the bumper cover onto the bumper support. Use a soft mallet.
CAUTION
Confirm that each bumper cover clip is fully interlocked with the bumper by reaching behind the bumper with your hand and feeling each latch.
Insert four wedge clips -1-, Part No. 191 807 153, into the bumper at locations "a" indicated.
CAUTION
Part numbers are for reference only. Always check with your Parts Department for latest information.