Drive Plate Removing and Installing

Drive Plate Removing and Installing





Removing
- Fasten counter-hold tool VW 558 to the drive Plate using M8 x 45 hex.bolt
Installed position of holder
A - to loosen
B - to tighten

Installing





- Install shims -1- and -2- as shown

- Note the indentations on shim -1-

- Insert new bolts -3- and tighten to 30 Nm (22 ft lb)
- Measure dimension -a- at three places and calculate the mean value

- Must be between 19.5 and 21.1 mm





If measured value is less than specification
- Remove driving plate again and add another shim -2-, re-tighten to 30 Nm (22 ft lb) and re-measure dimension -a-

- Measure and add shims as necessary until dimension -a- measurement is obtained

- Tighten screws -3- to 60 Nm (44 ft lb) + an additional 1/4 turn (the additional turn can be performed in stages)