Disassemble/Assemble
REVERSE CLUTCH - K2- 096 TRANSMISSIONDisassembling and Assembling
Note:
When performing repairs to the clutch, make sure that the ball valve (-arrow-) is not damaged.
1 - Circlip
- Mark after removing and install in same position
2 - Thrust plate
- Smooth side facing inner plates
- Thickness with clutches of:
4 inner plates 6.5 mm (0.256 in.)
5 inner plates 4.9 mm (0.193 in.)
3 - Outer plate
4 - Inner plate
5 - Corrugated washer
6 - Circlip
- Removing and installing
- Installation position
7 - Spring supporting plate
- With springs
- Installation position
8 - Spring supporting ring
9 - Piston
- Sealing lips are vulcanized to piston
- Moisten sealing lips with ATF before installing
- Turn piston slightly while installing
10 - Clutch housing with clutch tube
Removing and installing circlip (-arrow-)
Removing
- Carefully press down spring support plate (do not bend) and spread circlip.
Installing
- Fit on new circlip and carefully press down with spring supporting plate. Plate must be centered relative to hub otherwise spring supporting plate will be bent.
Installation position of spring supporting plate. checking circlip
- Circlip (-arrow-) must be seated in the groove of clutch housing.
- Spring supporting plate must he centered relative to hub.