OBD - Return TCM to Basic Setting
Automatic Transmission 096 - Returning to Basic SettingNote: The basic setting should be initiated after performing the following repairs:
^ Replacing engine
^ Replacing Throttle valve.
^ Adjusting throttle valve (setting idling speed).
^ Replacing Throttle Position (TP) Sensor -G69-.
^ Altering setting of TP Sensor -G69- when setting idle switch.
^ Replacing Transmission Control Module (TCM) -J217-.
1. Connect Scan Tool VAG 1551 and enter address word "02", Transmission Electronics, and advance until "Select function XX" appears in the display.
^ Readout in display:
Rapid data transfer HELP
Select function XX
2. Press buttons 0 and 4. (The function "Initiating basic setting" is selected with 04).
Note: Accelerator Pedal (AP) must remain in idle position.
^ Readout in display:
Rapid data transfer Q
04 Initiate basic setting
3. Confirm entry with Q button.
^ Readout in display:
Rapid data transfer HELP
Enter display group number XX
4. Press buttons 0 and 0.
5. Confirm entry with Q button.
^ Readout in display:
System in basic setting -->
6. The system is now in basic setting.
7. Depress Accelerator Pedal (AP) past kickdown and hold to floor for 3 seconds.
8. Press --> button.
^ Readout in display:
Rapid data transfer HELP
Select function XX