Standard Two Speed Fan Thermo Switch

LEGEND
1 Bolt
2 Cover
3 Lock Carrier
4 Air Intake Elbow
5 Bracket
6 Radiator
7 Rubber Washer
8 V~belt
9 Expandable Pin
10 Guide Shroud
11 Additional Fan
12 Fan Ring
13 Connector
14 Radiator Fan
15 Radiator Fan
16 To Coolant Pipe
17 Cap
18 To Expansion Tank Connection
19 Lower Coolant Hose
20 Connection
21 O-ring
22 Retaining Clip
23 Upper Coolant Hose
24 Coolant Fan Control Thermal Switch

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

COMPONENT NOTES
Bolt (1)
- Tighten to: 10 Nm (7 ft. lbs.).

Radiator (6)
- After replacing, completely replace engine coolant.

Guide Shroud (10)
- Note fitting position.
- Secured on lock carrier (item 3) with clips.

Cap (17)
- Test Pressure 1.3-1.5 bar (18.85-21.75).

Lower Coolant Hose (19)
- To water pump.

O-ring (21)
- Always replace.

Coolant Fan Control Thermal Switch (F18) (24)
- Tighten to: 35 Nm (26 ft. lbs.).
- Switching temperatures:

- Stage 1
On: 92-97°C (198-207°F)
Off: 84-105°C (183-196°F)

- Stage 2:
On: 99-105°C (210-221°F)
Off: 91-98°C (196-208°F)

- A three speed coolant fan control is used only with optional extra equipment, refer to Radiator Hose for location.