Distributor, Ignition

Distributor:

1 RFI Suppression Cap

2 Distributor cap

3 Distributor rotor, 1000 Ohms resistance
Note;The rotor is glued to the shaft.
If the rotor has to be replaced.
Remove it by destroying it with a pair of pliers.
Carefully remove any adhesive residue from the shaft and glue on the new rotor using adhesive AMV 185 100 01 or equivalent.

CAUTION
Do NOT hit the rotor, there is danger of damaging the rotor shaft or bearing.

4 5 Nm (44 in. lb.)

5 Dust shield

6 Distributor shaft
Before removing coupling (12) mark coupling position on shaft (6)
After removing shaft, pull Out pin (13)

7 Shims

8 Hall sensor

9 Distributor housing

10 0-ring, replace if damaged

11 Plastic shim

12 Coupling
Before removing coupling (12) mark coupling position on shaft (6)

13 Pin, always replace

14 Clip