GROUP II
GROUP II
1 - 5 Nm (44 in lb)
2 - Cover
- Over upper section of intake manifold.
3 - Ignition Wire Guide
4 - Left Rear Support
- Between upper section of intake manifold and cylinder head
- With engine ground connection
5 - 25 Nm (18 ft lb)
6 - Right Rear Support
- Between upper section of intake manifold and cylinder head
- With bracket for fuel line
7 - Cap
8 - Seal
- Replace if damaged.
9 - Hose
- For crankcase breather
10 - Cylinder Head Cover
- Removing and installing refer to "Cylinder Head Cover, Removing and Installing". Service and Repair
11 - 0-Ring
- Replace
- Lubricate with oil before installing in camshaft sprocket cover -12-.
12 - Camshaft Sprocket Cover
- Coat sealing surfaces with AMV188OO1 02.
- If only camshaft sprocket cover was removed, prepare cylinder head gasket for installation refer to Fig. 2 in "Cylinder Head, Component Overview". Service and Repair
13 - Chain Tensioner, 30 Nm (22 ft lb)
- For double chain
- Bleed before installing see Fig. 2 in "GROUP I". GROUP I
- Turn engine only with chain tensioner installed.
14 - Seal
- Replace.
15 - Bracket
- For 42-pin connector and pump for coolant after-run circulation.
16 - 1O Nm (7 ft lb)
17 - Ignition Coil (N152)
- Checking: Check DTC.
18 - Bracket
- For electric wiring
19 - Thermostat Housing
20 - 0-Ring
- Replace.
21 - Cylinder Head Gasket
- Replace.
- When replacing, also replace all engine coolant.
22 - Cylinder Head
- When replacing, also replace all engine coolant.
23 - Cylinder Head Bolt
- Replace.
- Note sequence when loosening and tightening.
24 - Lifting Eye
25 - Intake Manifold, Lower Part
26 - Gasket For Intake Manifold, Lower Part
- Replace.
27 - Ribbed Belt Tensioner
- Ribbed belt, removing and installing refer to "Ribbed Belt, Removing and Installing". Service and Repair
28 - Cylinder Head Cover Gasket
- Replace. Note installation position.
29 - Bracket
- For fuel lines.
30 - Gasket For Intake Manifold Upper Part
- Replace.
31 - Intake Manifold Upper Part
- First tighten intake manifold lower part, then the two rear supports -4- and -6-.
32 - Vacuum Hose
- To brake servo.