Clutch, M/T

Clutch/Flywheel Assembly




CAUTION!
Friction materials such as brake and clutch linings, or brake pads may contain asbestos fibers.
Do NOT create dust by grinding, sanding or by cleaning with compressed air.
Avoid breathing asbestos fibers and asbestos dust.
Breathing asbestos may result in serious diseases, such as asbestosis or cancer.
It may cause severe injury and death.

CAUTION! Part numbers are for reference only. Always check with your Parts Department for latest information.


1 - Seal flange
- coat sealing surface with AMV 188 001 02
- if flange has been removed check and prepare cylinder head seal, see Repair Group 15
2 - 25 Nm (18 ft lb)
3 - 10 Nm (7 ft lb)
4 - Oil seal
- remove with tool 2086
- installing: lightly lubricate sealing lip and outer edge install with pull sleeves from tool 2003/2A press in seal to stop with tool 2003/1
5 - Flywheel
- can be replaced with engine installed
- removing 5-speed transmission
- hold flywheel with tool 558 when removing
6 - 60 Nm (44 ft lb) + 1/4 (90°) turn
- always replace
7 - Clutch disc
center with tool 3190 A
8 - Pressure plate
- when removing, hold flywheel with tool 558
- note installed position with TDC marking for No 1 cylinder (rounded, ground down tooth)
9 - 20 Nm (15 ft lb)
tightly diagonally
10 - 10 Nm (7 ft lb)