Throttle Body, Lower Section

Throttle Body, lower section, component layout





1 - Throttle Position (TP) Actuator (V60)
^ With Closed Throttle Position (CTP) Switch (F60)
^ Checking. Testing and Inspection
^ When installing, CTP Switch must only be operated by Switch plastic plate with stop screw -6-
^ If necessary loosen bracket -4- and align
2 - 6 Nm (53 in lb)
3 - Closed Throttle Position (CTP) Switch (F60)*
^ Checking. Testing and Inspection
^ To replace, replace complete Throttle Position (TP) Actuator -1-
4 - Bracket with holder for accelerator cable
5 - Grommet
6 - Stop screw
^ For Closed Throttle Position (CTP) Switch -3-
^ Checking and adjusting. Testing and Inspection
7 - Throttle Body, lower section
8 - Stop screw
^ Factory sealed
^ DO NOT adjust
9 - O-ring
^ Always replace
10 - Elbow-connector
^ For Evaporative Emission (EVAP) Canister
11 - Bracket
12 - 3 Nm (27 in lb)
13 - Vacuum connection
^ For Intake Air pre-heating
14 - Retaining clip
^ For Throttle Body, upper section
15 - Throttle Position Sensor (G69)*
^ Checking. Testing and Inspection
^ DO NOT adjust
^ Replacing: replace Throttle Body, lower section
^ Vehicles with automatic transmission: must be matched with Transmission Control Module (J217)
16 - Water trap
^ For Throttle Position (TP) Sensor (G69)
17 - Tie-wrap

* Tested by On Board Diagnostic program. Testing and Inspection