Remove/Install

ATF PUMP TO SUPPORT TUBE 096 TRANSMISSION







Note: Refer to Planetary Gearbox Disassembly/Assembly Planetary Gearbox Disassembly/Assembly

1 - Bolt
- Qty. 7
- Tightening torque: 8 Nm (71 in lb) plus an additional 1/4-turn (90°)
- The additional 1/4 turn (90°) may be done in several stages

2 - ATF pump with -B2- piston
- Disassembling and assembling Disassemble/Assemble

3 - O-ring
- Always replace
- Place on ATF pump

4 - Gasket
- Always replace

5 - Spring cap
- Qty. 6
- Install 3 spring caps after installing first outer plate
- Install 3 spring caps before installing last outer plate

6 - Spring
- Qty. 3

7 - Corrugated spring washer

8 - Outer plate -B2-
- Quantity
- Determining thickness of outer plate, 2nd and 4th gear brake -B2-, adjusting

9 - Inner plate -B2-
- Quantity
- Before installing, place in ATF for 15 minutes


10 - Outer plate -B2-
- Always install outer plates that are 2 mm (0.079 in.) thick
- Quantity

11 - Outer plate -B2-
- Fit 3 mm (0.118 in.) thick outer plate to supporting tube

12 - Supporting tube -B2-
- For -B2- plate package
- Length of -B2:
with 4 inner plates 72.3 mm (2.846 in.)
with 5 inner plates 68.6 mm (2.701 in.)
with 6 inner plates 64.9 mm (2.555 in.)
- Quantity of-B2- inner plates
- Insert so that groove en gages in wedge of free wheel