Roof Trim Assembly/Headliner - Removal
Group: 70Number: 93-01
Date: April 30, 1993
Subject:
Roof trim assembly/headliner, removing
Model(s):
Golf III / GTI /Jetta III
from 1993 m.y.
The following roof trim/headliner information will be added to the Golf III/GTI/Jetta III Repair Manual - Body - Exterior / Body - Interior, at the next reprinting.
Roof trim, assembly
1 - Headliner
2 - Trim strip, rear
3 - Grab handle cap
4 - Grab handle
5 - Screw
6 - Spacer
^ For interior light
^ On vehicles with sliding/tilting roof, spacer is located in front of interior light cutout
7 - Center mark
^ Align to center of vehicle (center clip hole)
Headliner, removing
- Disconnect battery ground cable
- Carefully pry out interior light with screwdriver
- Remove cable drive cover and sliding roof cutout beading (vehicles with sliding/tilting roof only)
- Turn sun visor -1- 90°, remove screws and, if necessary, separate connector
- Remove sun visor mounting -2-
A-pillar trim, removing
- Remove screw -1- and pull A-pillar trim off
(note position of lug -3- and securing clip -2-)
B-pillar trim, removing
- Remove seat belt B-pillar attachment, if necessary
- Pull off B-pillar trim -1-
Note:
^ Securing clips -3- (2-door vehicles only) and -4- stay on B-pillar
^ Tabs on sides of trim grip onto beading on B-pillar
^ Plate -2- is clipped into B-pillar trim -1-
C-pillar trim, removing
- Remove screw -1- and pull oft upper part of C-pillar trim
- Remove remaining fasteners and pull off trim
2 - Securing clip
3 - Seal
4 - Spring plate
5 - Nut
Rear trim strip, removing
- Pull trim strip off
1 - Securing clip
- Remove grab handles
Note:
On vehicles with a sliding/tilting roof, the front grab handles are marked with a "V" and the rear grab handles with an .
- Lower headliner and remove from vehicle (requires a second person to prevent damage to headliner)