Locking Cable Removing and Installing

LOCKING CABLE REMOVING AND INSTALLING, 096 TRANSMISSION







Note:
- Locking cable must not be kinked.
- Adjust locking cable after installing

Removing
- Remove selector lever handle.
- Remove cover with cover strip.
- Remove center console.
- Loosen cable anchor screw, take locking cable out of locking lever and pull out of cable anchor.
- Remove locking cable from clip (arrow).
- Remove trim pieces from ignition/starter switch.
- Press locking cable clip out of ignition/starter switch and remove locking cable from ball head.
- Take out locking cable.






Installing

Note:
Ensure proper routing of locking cable when installing.

- Install locking cable in vehicle.






- Mount locking cable eye -1- on locking lever -a-.






- Install locking cable in cable anchor.

- Do not tighten screw -a- until after adjusting locking cable.






- Mount locking cable clip on locking cable first.

- Press locking cable onto ball head.

- Press locking cable with clip into support bracket for Ignition/Starter Switch.






- Route locking cable along steering column.

- Adjust locking cable on cable anchorage of selector lever

- Install center console.

- Install cover with indicator and selector lever handle Attach trim for Ignition/Starter Switch.