Sealing Flange and Flywheel/Driveplate, Removing and Installing

LEGEND
1 Auxiliary Shaft Oil Seal
- To remove, remove sealing flange.
- Install using installer tool No. 10-203, or equivalent.
- Lightly oil sealing lip, do NOT use grease.
2 Woodruff Key
- Ensure tight fit.
3 Bolt
- Tighten to: 25 Nm (18 ft. lbs.).
4 Front Sealing Flange
5 Gasket
- Always replace.
6 Cylinder Block
7 Bolt
- Always replace.
- Tighten in two stages:
- First stage, tighten to: 60 Nm (44 ft. lbs.).
- Second stage, turn an additional: 90° (1/4 turn).
8 Pressure Plate or Drive Plate
- Note installed position of washer for mounting bolts.
- Use counter holder tool No. 3067, or equivalent to remove and install.
- Refer to Transmission and Drivetrain.
9 Bolt
- Tighten to: 10 Nm (7 ft. lbs.).
10 Intermediate Plate
- Must be located on dowels.
- Do not damage/bend when assembling.
11 Rear Oil Seal Flange with Seal
- Only replace complete.
- Lightly oil sealing lip of oil seal, do NOT grease.
12 Front Crankshaft Oil Seal
13 Auxiliary Shaft
14 O-ring
- Always replace
15 Sealing Flange For Auxiliary Shaft