Disassemble/Assemble

COMPONENT NOTES AND INFORMATION
1 Piston ring
- Check that it is correctly located
- Installing, refer to Fig. 2, below.
2 Piston ring
- Check that it is correctly located
- Installing, refer to Fig. 2, below.
3 Piston ring
- Check that it is correctly located
- Installing, refer to Fig. 2, below.
4 Thrust washer
5 Piston
- Sealing lips are vulcanized to the piston
- Moisten sealing lips with ATF before installing
- Turn piston slightly when installing
6 Bolt
- Tighten to: 10 Nm (7 ft lb) plus and additional 1/8 turn (45°)
7 Stator support
8 Outer gear
- Manufacturer's marking (arrow) faces stator support
- If outer gear is incorrectly installed, the ATF pump may not operate freely in the installed position
9 Inner gear
- Larger groove faces stator support
10 Housing for ATF pump
11 O-ring
- Always replace
12 Torque converter oil seal
- Removing and installing, refer to Replacement. Service and Repair

PROCEDURES





Fig. 1 Piston rings, checking correct location
- Ensure that ends of piston rings are hooked together.





Fig. 2 Piston rings, installing and hooking ends together
- Place piston ring in groove.
- Press sides of ring in and guide ends over one another.

NOTE: Do not twist piston ring out of groove on one side.