Steering Column Assembly
Steering column assemblyCAUTION: Do not attempt to weld or straighten steering parts. Always replace self-locking nuts and bolts
Note: All parts marked with an asterisk * can be assembled outside the vehicle
1. Cover
2. 40 Nm (30 ft lb)
3. Washer
Approximately 3 mm (1/8 in) thick
. Steering wheel
Install with steering system in center position
5. Multi-tooth adaptor sleeve
removing/installing, Multi Tooth Adapter Sleeve
6. Spring
7. Lower cover
8. Steering lock housing*
Push onto steering column tube to stop
Space between steering wheel and column switch cannot be adjusted
9. Upper cover
10. Support ring*
push onto steering column
11. Steering column*
To remove pull up out of column tube
Checking length section zzz
Assembling section zzz
12. Hex bolt 5 Nm (18 ft lb)
13. 30 Nm (22 ft lb)
14. Universal joint shaft
15. Spring
16. Bearing
For lower steering column
Drive out in downward direction with tube
Install using VW 771 and a large washer
17. Shear bolt 25 Nm (18 ft lb)
18. Washer
19. Column tube