Checking Rear Window Wiper/Washer System

Use test system VAG 1466 for troubleshooting.

Test Conditions:
^ Fuses no.4 (15A) OK
^ Rear wiper in end position

Preparation for Troubleshooting
- Remove rear window wiper/washer relay J30 (production control number 72) from relay location 2.
- Remove washer/wiper intermittent relay J31 (production control number 99) from relay location 8.
- Insert test adapter VAG 1466/3 into relay location 2.
- Connect VAG 1466 to test adapter.

Troubleshooting - Checking Rear Window Wiper/Washer System (Part 1 Of 2):

Troubleshooting - Checking Rear Window Wiper/Washer System (Part 2 Of 2):

Troubleshooting Procedure
- Perform test steps according to table.
- If specified value/test result is obtained, proceed to next step (test result OK).
- If specified value/test result is not obtained, use table for troubleshooting and repair.
- Use valid wiring diagram for wire testing.
- Disconnect test leads after each step.

NOTE:
- If malfunction has not been eliminated after performing steps 1 to 5, replace rear window wiper/washer relay J30.
- After repairing malfunction, perform functional test of rear window wiper/washer system.