Ignition System Layout From Jan. 1993

Ignition Components:

Components

1 Camshaft Position sensor (G4O)*.
Note spacers.

2 10 Nm (7 ft lb).

3 Harness connector (5 pin) for ignition coil.

4 High tension spark plug cable.

5 RFI suppression connector.

6 Ignition coil (N152)*.
With ignition cable identification, do not interchange spark plug cables.


7 Camshaft sprocket cover.

8 Harness connector (3 pin).

9 Proper Torque is critical, 20 Nm (15 ft lb).
Tightening torque influences the function of the knock sensor.

10 Knock sensor II (G66)*.
Location: engine block, intake side.

11 Trigger wheel For Camshaft Position sensor (G4O).

12 Knock sensor I (G61)*.
Location: engine block, exhaust side.

13 100 Nm (74 ft lb.).
To remove or install, counter-hold with 24 mm open-end wrench on camshaft.
Oil contact surface of bolt head.

14 Spark plug, 25 Nm (18 ft lb.).
Use 3122B adaptor to remove and install.

15 Spark plug connector.
Use 3277 adaptor to remove and insert.

16 0-ring, replace if damaged.

17 Harness connector(3 pin) for Camshaft Position sensor (G4O).