Fuse/Relay Panel, Removing and Installing

Fuse/relay panel, removing and installing

CAUTION! Before working on the electrical system:

- Obtain radio anti-theft code.

- Ignition OFF!

- Disconnect battery Ground (GND) strap.


Notes: After reconnecting battery:

- Activate vehicle vehicle equipment such as radio, clock and power windows as per Repair Manual and/or Owner's Manual.

- On vehicles with OBD II, activate readiness code

- The fuse/relay panel is located under the left side of the instrument panel.

Remove lower instrument panel trim





- Spread retaining clips -1- and disengage bc pins -2- from brackets -4-.

- Swing retaining clips -1- forward and pull from fuse/relay panel pins -3-.

- Spread left retaining bracket -4- and disengage from pin -5-.

- Lift fuse/relay panel from brackets -4-.

- Remove multi-point connectors from back of fuse/relay panel and remove fuse/relay panel.

- Install in reverse order of removal. Make sur pin -5- and retaining pins -2- engage recess brackets -4-.