Camshaft Oil Seal, Removing and Installing

Camshaft Oil Seal, Removing And Installing

Special tools, testers and auxiliary items
^ Holder tool 3036
^ Oil seal extractor 2085
^ Oil seal installation tool 10-203

Removing

- Remove upper drive bell guard.

- Loosen camshaft sprocket (hold with 3036).





- Rotate camshaft drive belt sprocket to Cyl.- TDC mark by turning crankshaft.

^ Mark on camshaft sprocket must align with arrow on toothed belt guard.

- Loosen tensioner and remove toothed drive belt.

- Remove camshaft drive belt sprocket.

- Remove Woodruff key from camshaft.

- Install camshaft drive belt sprocket mounting bolt with washer into camshaft and thread in to stop.

- Turn inner part of seal puller 2085 out two turns (approx. 3 mm from the outer part and lock with knurled screw.





- Lubricate threaded part of seal puller, install and, while applying pressure, screw into seal as far as possible.

- Loosen knurled screw and turn inner part against camshaft sprocket mounting bolt until seal is pulled out.

- Clamp flat surfaces of puller in vise.

- Remove seal from puller with pliers.


Installing

- Oil sealing lip.

- Install seal with sleeve from 10-203 and press in flush with outer surface of cylinder head.

- Install toothed drive belt and adjust tension.