Without Air Conditioning

CAUTION: Before working on electrical system, obtain radio code and disconnect battery Ground (GND) strap.

NOTE: All available procedures for servicing components are not necessarily in this article alone. If the information needed is not found in this article, try looking for information under specific component.





1- Plenum chamber cover
2- Dust and pollen filter
3- Hex screw with shank M6x22
- 5 Nm (44 in lb)
4- Gasket
5- Series resistor for fresh air blower with thermal fuse -N24-
6- Fresh air blower -V2-
7- Footwell vent
8- Air duct right
9- Air distribution
- Replacing center vent -12-, heating and fresh air controls -22-, remove shelf on passenger side; Loosen instrument panel -20- and lift
10- Air vent, right
11- Grille for Right Vent
12- Center vent
13- Control panel trim
14- Grilles for Center Vent
15- Instrument panel trim
16- Grille for Left Vent
17- Air vent left
18- Rear duct
- Replacing: Remove console, instrument panel bracket, pedal cluster cover -23-, footwell outlet -7-
19- Rear duct seal
- Replacing: Remove console, instrument panel bracket, pedal cluster cover -23-, footwell outlet -7-
20- Instrument panel
21- Air duct left
22- Fresh air and heated air controls
23- Pedal cluster cover
24- Cables
- Replacing: First remove pedal cluster cover -23- and foot well outlet -7-
25- Intermediate duct
- With gasket
- Replacing - remove instrument panel first
26- Air distribution housing
- With temperature flap
- With center flap
- With footwell/defrost flap
- Do not disassemble further
- Replacing: Remove instrument panel and heating items -22- to -28-. Heater Core
27- Heat exchanger
- Replacing: Remove instrument panel and heating items -22- to -28-. Heater Core
- After heat exchanger replacement, install fresh coolant
28- Air duct with main shut- off flap
- Replacing: Remove instrument panel and heating items -22- to -28-. Heater Core
29- Hex nut M6
- 5 Nm (44 in lb)