Sliding/Tilting Roof Glass Panel, Installing

Sliding/tilting roof glass panel, installing

Panel must be installed in "0 position" (panel closed).

0 position:





- Pin -3- must be within the marks (notches) -arrow-.

- Locating hooks -4- must be located in the guide rails.

- Place sliding/tilting roof on from above and install mounting screws for lever/panel.

- Lightly tighten mounting screws (Torx T25).

Notes:





- When tightening the Torx screw -1- ensure that the adjusting plate -2- is correctly located (the adjusting plate is an integral part of the connecting guide).

- After adjusting panel height tighten mounting screws to 6 Nm (53 in. lb).