Cable Drive

Sliding/tilting roof with glass panel

Cable drive, checking 0 position





If the cable drive is replaced, it must be installed in "0 position" (sliding/tilting roof panel closed).

- Connect cable drive wiring harness connector to sliding/tilting roof wiring harness.

- Operate switch -1- and count rotations of drive pinion -2-: The "0 position" of the cable drive is between the end switch-off points -A- and -B-.

- The end switch-off point -B- is obtained by turning drive pinion clockwise and the end switch-off point -A- by turning counter-clockwise.