Throttle Body, Upper Section

Throttle Body, upper section, component layout





1 - 5 Nm (35 in lb)
^ Secure with D6
2 - Protective cap
^ Only on replacement part for protection during shipping (discard)
3 - Housing for Fuel Injector (N30) with Intake Air Temperature Sensor (G42)
^ Measure resistance of G42 between outer terminals of connector -12-
^ Resistance values, Fig 1 below
^ G42, checking. Testing and Inspection
4 - 0-ring
^ Always replace
5 - Fuel Injector (N30)
^ Checking. Testing and Inspection
6 - 6 Nm (53 in lb)
^ Secure with D6
7 - Throttle Body, upper section
8 - Gasket
^ Note installation position
^ Always replace
9 - Adapter
10 - Seal
^ Always replace
11 - Fuel Pressure Regulator
^ Checking. Testing and Inspection
12 - Harness connector
^ Unlock to remove





Fig. 1 - Temperature sensor resistance
^ Intake Air Temperature (IAT) Sensor (G42)